Towerbuster Tutorial.

By Cesco

The Towerbuster is a small, usually muffin shaped, orgone generator, to learn more see the terminology page.
This tutorial will show how to make simple and potent TBs suitable for gifting outdoors.
Note that it is recommended that one charge the crystals to be used, this makes the TB more potent, click here for charging methods.

Required materials:

Polyester or Epoxy resin, cheap stuff is prefered, this turns either brow/yellowish or purple when cured.

Catalyst/Hardener for the resin.

Syringe(witouth needle) for measuring correct amount of Catalyst(Not necessary if catalyst comes with a dropper.)



Metal Shavings (Aluminum used in tutorial, brass, copper, titanium etc. all work fine).



Quartz Crystal Points, amount depending on how many TBs you are making.
Size approximately as shown in picture.
Charge your crystals beforehand.



Teflon coated Muffin tray (or other mold, though a teflon coated muffin tray is probably the most practical one can use).
Makes 12 TBs a pop without any need of release agent.



( Mold Release Agent, a thin coat of cooking oil is suitable for most molds, it is not necessary to buy expensive mold release agent.)
This is only needed if you use another type of mold than the teflon coated muffin tray.

Rubber Gloves(!)

Measuring Jug.



Stirring stick (An old spoon also works fine.)


It is recommended that you work outside or in a well ventilated area, use a protective mask if working indoors.
Cover work space with some plastic to avoid stains/mess.

---------------------------------------------------------------------------------------------------------------------------------------------------------------


Step 1.

Fill your muffin tray with metal shavings:

( If using a different mold: prepare your mold with release agent, just a thin layer is necessary.
This is easiest done without gloves on, place a few drops of oil in the glass and distribute it with your fingers, cover the top edge of mold as well. When done remember to put you protective gloves on.)

Step 2:

Insert you crystal points into the mold, bury them into the shavings so that they are completely covered:
It is not very important which way the end of the crystal goes into the mold.

Remember to keep your crystal either in the charged water or pyramid charger until this stage so that it does not lose its charge.
(Optional: If you want to raise the energy a bit you can add some small pieces of rose quartz or peridot.)

Step 3.

Measure the correct amount of resin into your measuring jug.



(To determine how much is needed per TB/Muffin tray one can beforehand fill ones mold with water and measure how much is needed.)
Place the correct amount of catalyst into the resin, mix thoroughly with your stirring stick.
Depending on weather you have between 10-30 minutes before resin starts hardening.


Step 4:

Pour to cover with your resin and let sink properly into the shavings.
You can make sure that it sinks to the bottom by using a small stick and poke around the sides of each muffin.


Step 5:

Leave to cure.
Curing process takes anything from an hour to overnight, when mold is cold to touch it is usually done.
Have patience:)

Step 6:

Remove your TBs from your mold by tipping it upside down.
A properly cured TB should pop right out, if it seems to be stuck try first placing it on a warm oven and then into a freezer and give it a gentle tap, that usually does the trick.

Step 7:

With joy and celebration go out into the world and gift your glorious TBs :)



back