Orgonite Water Charger Tutorial.

By Cesco.

 

 

This written tutorial will give instructions on how to make a simple but very potent Orgone generator that will permanently charge water and also the strength of crystals.
This generator was for a period sold through Materiaetherica under the name Aquaetheric Generator.
What makes it able to charge water is that it is cured on top of a CB which gives it the same vortex spinning properties that changes the energy structure of water.
So you need a CB to make this generator.

You will need the following components:

Required materials:

Polyester or Epoxy resin.

Catalyst/Hardener for the resin.

[Syringe (without needle)] for measuring correct amount of Catalyst(Not necessary if catalyst comes with a dropper.)



Metal Shavings (Aluminum used in tutorial, brass, copper, titanium etc. all work well).
Recommended to use one metal type only.



One Quartz Crystal Point, size depending on depth of your mold.
Single Terminated recommended as it is easier to determine the positive end.
Charge your crystal beforehand.



Cylindrical mold(not conical), a muffin pan shape like used to make TBs works fine.
Remember that the mold should be deep enough to fit the length of your crystal.

Mold Release Agent, a thin coat of cooking oil is suitable for most molds, it is not necessary to buy a expensive mold release agent.

Rubber Gloves(!)

Measuring Jug.



Stirring stick (An old spoon also works fine.)

CB.

It is recommended that you work outside or in a well ventilated area.
Use a protective mask if working indoors.
Cover work space with some plastic to avoid stains/mess.


Step 1.

Prepare your mold with the release agent, just a thin layer is necessary.

This is easiest done without gloves on, place a few drops of oil in the mold and distribute it with your fingers, cover the top edge of mold as well. When done remember to put you protective gloves on.

Step 2.

Measure the correct amount of resin into your measuring jug.



(To determine how much is needed per Generator one can beforehand fill ones mold with water and measure how much is needed.)
Place the correct amount of catalyst into the resin, mix thoroughly with your stirring stick.
Depending on weather you have between 10-30 minutes before resin starts hardening.

Step 3:

Fill your mold halfway with metal shavings and insert your crystal in the center, positive end upwards into it (This is important.)

Pour to cover with your resin and let sink properly into the shavings.


Step 4:

Cover the remaining part of your mold and crystal point with metal shavings.
And pour resin to cover everything, making sure that it sinks to the bottom.

Then place the filled mold ontop of the top template of your CB, the top template should be at least 3 feet above the base and the mold with ingredients should be placed in its center.
If you have a 7 pipe Torsion CB remove the center pipe.
(Do not cure the generator above any of the 6 pipes)

Leave to cure.
Curing process takes anything from an hour to overnight, when mold is cold to touch it is usually done.
Have patience:)

Step 6:

Remove your Orgonite Water Charger from your mold by tipping it upside down.
A properly cured device should pop right out.
If it seems to be stuck, try first placing it on a warm oven and then into a freezer, and give it a gentle tap; that usually does the trick.

Step 7:

The generator needs to be placed 10-15cm below the container of water with air between for the water to charge, the generator needs to be placed with the side that has the positive end of the crystal going upwards beneath your water.
You can also charge crystals by placing them in water above the charger.
It takes around 3 hours for the energy structure to change but leaving it abit longer can be a good idea.
Charging methods can be found here.

With joy and celebration start charging your drinking water.

back